This item has been shown 1061 times.
Hello, here is a racer or engine builders dream. Go fast for less than a third the cost.
This is a Pro mod engine that was starting the assembly process when stopped. Grind the cam to your specs and assemble.
Don't miss out on this giveaway!
903 Pro Mod Parts List
1 CN Billet block with 5 runs before sleeve change to steel Nicasil sleeves at 5.075. There is still a .225 bridge between cylinders. This block is honed and assembled with a brand new Sonny Bryant 5.600 strocke crank.
1 set 959 Billet Dart heads used but fresh with new PSI springs and JHE retainers and locks
1 set 903 Billet Dart heads reworked to 959 specs with new Xceldyne 2.775 intake valves (23 new valves hollow stem, 26ea new Xceldyne 2.015 exhaust)
6 new head gasket sets
1 set Jesel shaft rockers with 5 runs
16 Jesel lifters new 1.095
4 70MM Billet cam cores so you can grind what you want.
1 Jesel belt drive
1 front mount Jesel distributor with wires
1 ATI damper
1 MSD crank
16ea. 5/8 pushrods used 5 runs.
8 new GRP rods
10 new diamond pistons
8 new Trend wristpins and clips
1 new total seal ring set
1 Dailey 6 stage oil pump
1 Peterson dry sump tank
All oil lines
Moroso 2 piece pan
1 vacuum pump
1 Waterman cam drive fuel pump
1 Weldon fuel pressure regulator
1 Weldon filter and fuel lines
Feel free to call me at JHE to discuss.
Thank you for looking!