This circuit is taken directly from Stan's original Electrical Polarization Process Box:
Typical Setup Installed In a Vehicle to Reduce Gasoline Usage:
Reasons To Use Stan's Electrical Polarization Process Board on your Vehicle:
Frequently Asked Questions
Q.Does This Produce HHO Gas?
A.Yes, the amount of gas produced depends on how high the Powerstat transformer is set, and the distance between the cell plates
Q.What kind of fuel cell can be used with it?
A.Stan's Electrical Polarization Process Box was designed to work with his movable distance plate cell, but it will work with tube cells also. If you read Stan's patents, you will see he mentions that tube cells are more efficient, but either type of cell will work
Q.What kind of water do I use?
A.Stan designed this as a test for the patent office, and designed it to run from normal tap water. Therefore, no electrolytes or additives are required! Just add tap water, rain water or well water! Distilled water will work if the circuit is operated at the highest voltages, but it does not produce as much gas as the tap water it was designed to work with
Q.Will this let me run my car on 100% water?
A.No, it will not run it completely on water, but will allow you to use less gasoline than you would without it. The ultimate goal is to REPLACE gasoline, but we must work one step at a time. Using less gasoline is a first step while we further develop Stan's work.
Q.I see you have an EFIE in the diagram. Did Stan use an EFIE in his designs?
A.No, Stan had no need for using an EFIE (Electronic Fuel Injection Enhancer), as he ran pure HHO gas and adjusted the burn rate of hydrogen to co-equal that of fossil fuel. In short, he slowed the burn rate down so the HHO gas burned just like gasoline. To date, no one has solved all of Stan's designs, so we are offering a hybrid design, something that will help people save on gasoline Now - while we are solving Stan's advanced, final designs. Stan did not use an EFIE in his final designs, but we need to start somewhere, and saving some on gasoline is a lot better than saving none!
Q.Why is the completed Stan Meyer board so expensive?
A.The main reason for the price difference is because the assembled board is soldered, wired and tested by hand. We have to cover the time required to do all of this, and it takes a lot of time to do this right. Most people prefer to have the kit already assembled, so all they need to do is connect it to their fuel cell and they are done!
Q.What is the difference between this and the cells I see all around the internet?
A.Stan's setup is completely different that the prior art in many ways. Here are just a few:Traditional ElectrolysisStan's TechnologyCurrent Draw15+ Amps Per cell, Depending on Amount of Electrolyte>2 Amps Per Entire Fuel Cell, Much Less When Constructed ProperlyRequires Electrolytes Be Added To WaterYes - Must add KoH, NaOH, Baking soda, or other caustic chemicals. Some chemicals can eat aluminum engine parts and create toxic gasesNo Additives required. Simply add tap water rain water or well water. No toxic gunk produced that must be disposed ofLifetime of Fuel Cell's Metal PartsDepends on temperature and current of cell. Metal parts eventually dissolve into liquid, creating a toxic slurry that requires special disposal. Dissolved elements include Chromium and othersDepends on type of water used. Metal parts never dissolve into water, maintaining a clean liquid in the cell. If only natural water is used, Stan's tests show lifetime of cell parts is close to 10,000 YearsRequires a special coating or conditioning processNoNo