BMW E46 Cluster Clock Adjuster Fix - All Models - Original For Sale

BMW E46 Cluster Clock Adjuster Fix - All Models - Original


When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Buy Now

BMW E46 Cluster Clock Adjuster Fix - All Models - Original:
$12.90

SHIPPING NOTE!!- Shipping to outside from Europe can take up to approx. 4-6 weeks, average time 2 weeks. Within Europe approx. 1-2 weeks, Hungary 2-3 days.- "Standard shipping" means I send it with Tracking Number, "Economy" is without Tracking No.Thank you!
Dear Viewer!If you are here, might your cluster has already broken at the clock adjustion part. This product is a fixture that provide your clock adjusting function will work again in your lovely BMW E46's cluster. Original development, bad copiescan be harder to use and easier to break!
Durable raw material is ASA, which is more resistant to UV, heat and cold than PETG and ABS. The bottom part of the ring is thicker for the purpose of strengthening the structure.
There's a short video about the installation and a proof about for the installation video by Jin Endow's Youtube notes:- Use latex gloves during installation to prevent the cluster from fingerprints- Try not to touch the needles, or take a picture before the install, for help to set it back to position
Installation guide:
  1. Remove the cluster from your car
  2. Remove 4 torx screws with a T8 screwdriver from the back
  3. Pull off the top, rubber black black adjuster needle
  4. Remove the back of the cluster
  5. Remove the black adjuster needle
  6. Remove the residuals of the original, white adjuster levers with a scalpel/papercutter
  7. Put the end tip of the fixture below the edge of the cluster and push down the whole fixture with your fingertips/screwdriver. Please pay attention the ring of the fixture is around the white round stuff on the cluster
  8. Put back the black adjuster needle and assemble the cluster
  9. Enjoy :)
I use this in my car too, and it works like a charm. Before the installation, I tested it between -30 and +80°C degrees, and I didn't found any problems/cracks.It is a 3D printed part with ASA, it is really durable, plus heat, cold and UV-resistant.
If you have any further questions, feel free to contact me! I do my best to figure out the topic!

Buy Now

Latest Reviews

Send us a Tip